Product Information [Back to FAQs]
 
  1. ColorFill
  2. MitreBond
  3. Worktop Jigs

  1. ColorFill

     What is the shelf life of ColorFill? 24 months – ColorFill is completely Frost Free and is best stored in cool conditions. Do you have a ColorFill chart? You can visit the ColorFill database by clicking on this link - ColorFill Database - and filling in your worktop details. How many ColorFill tubes will I need per worktop joint? One 25g ColorFill tube is sufficient to join one worktop joint. How do I remove any excess ColorFill from laminate? Repairing Chips and Scratches – Use ColorFill solvent and a white tissue being careful not to dislodge any ColorFill from the repaired area.  A final coat of ColorFill can be applied later if necessary. Sealing Worktop Joints – Use ColorFill solvent and a white tissue being careful not to dislodge any ColorFill.  Do this by cleaning across the joint at 90 degrees to the cut at all times.

    [Back To Top]

  2. MitreBond

     What is the shelf life of MitreBond?  1 Year – The shelf life of the adhesive can be shortened if left in conditions over 25°C, and prolonged in cold conditions. How do I remove MitreBond which has been spilt onto a laminate top? You need to use ColorFill Solvent.  It is however a slow process, never attempt to remove the cured adhesive with a knife or scraper.

    [Back To Top]

  3. Worktop Jigs

     Can I use my existing router with Unika Jigs? You need a guide bush with an outer diameter of 30mm and a 12.7mm diameter cutter.  We recommend routers rated at a minimum of 1500w for cutting worktops.  From listening to Kitchen Fitters and Carpenters over the years we have compiled the following trouble shooting guide to help overcome common problems encountered when using a Unika Jig.  Used correctly, your jig will give perfect results every time. I am getting a poor finish on male/female joint faces? Probable cause: Incomplete routing processRemedy: Ensure final stroke against far edge of centre slot is performed I am getting a sharp angle near the postform edge on male/female? Probable cause: Incomplete routing process.Remedy: Ensure final stroke against far edge is performed I am getting a good finish but the male & female do not match up? Probable cause: Incorrect size of cutter and/or guide bush.  Remedy: Ensure you are using a 12.7mm cutter and 30mm guide bush, nothing else is suitable I am getting inconsistent results for example wandering edges? Probable cause: Loose guide bush.Remedy: Ensure the guide bush is firmly attached to the router base There are irregular gaps on RH male and/or LH female face? Probable cause: Poor router controlRemedy: Ensure the cutter remains absolutely perpendicular on these cuts     

    [Back To Top]